Honeywell t-stat

Check out some similar questions!

Wiring a honeywell L641b 1004 pipe stat with a normal air monitored frost stat [ 0 Answers ]

I have a garage located boiler with a typical frost stat above it .I have a honeywell L641b 1004 pipe stat that I wish to monitor the return to boiler . If possible I would like to wire it so that the system fires up on hot water and not heating , I hope this makes sense.. I have a y plan..

New honeywell t-stat [ 3 Answers ]

I replaced an old Hunter t-stat when the unit ran continually no matter what temp... I replaced it with a Honeywell 6350 5-2 programmable t-stat. I have an old Coleman furnace with an ac unit attached using two wires-red/white. I connected the red to R and the white to W. There was already a...

Replacing honeywell stat to an other honeywell stat [ 19 Answers ]

I'm switching my old stat to a new one that lets me enter a program. I have an electric central air furnace and a thermopump outside that provides heat and AC. I'm going from a honeywell CT3600 or so (looks the same as in the manual for that one but without the program buttons) to a RTH8500....

Honeywell t-stat [ 2 Answers ]

I have a problem. I am NOT an electrician nor do I want to be one. I have been shocked more times in my life than I can count. I just remodeled my bathroom and put in a new gfci and a hot tub and new light fixtures. I thought I would get brave and replace all of the t-stats in my house with new...

Honeywell stat to braeburn [ 1 Answers ]

I have a honeywell stat t8734c1432. I replaced it with a braeburn 5000. I have a staights cool outside condenser and a gas furnace in the attic. I have no heat after changing the stats. The honeywell is a 4 wire stat with a jumper between the y terminal and terminal 1. white is to w, red to r,...

View more questions Search

Check out some similar questions!

Add your answer here.