 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
Luxaire propane furnace.. 4yrs old. Following a power outage... the furnace pre blower comes on fan comes on but no heat. Furnace is flashing 3 flashes . Filter is clean and blower motor seems to work on fan. Any thoughts.. Thanks Greg
I have a LUXAIRE model # G2FD046S17A my outside unit works fine but the blower that pushes air into the home does not come on.
My furnace manual says I can set the fan off delay on the PC board.my model has no such jumper that I can see.does the primary limit switch (open@140/close@100)control the blower? After gas shutoff the blower runs twice as long as I would like, sending cold air into the rooms.
As far as I can tell I have an ignitor problem. Works intermittantly. Filter is clean, pre-blower activates appropriately and IF ingnitor comes on, then the gas ignites and all is well. Thoughts?
I have a 2334 sg. Foot log home it has 2 3.50 ton units 1 of the units runs twice as much as the other.these are brand new units been in house less than year.Had the heat and air company back out to my house 4 times can't really tell me why they have closed down some vents at units didn't really...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
