Ask Experts Questions for FREE Help !
Ask
    SM638's Avatar
    SM638 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    May 22, 2010, 06:00 PM
    Luxaire furnace troubleshooting
    I have a LUXAIRE model # G2FD046S17A my outside unit works fine but the blower that pushes air into the home does not come on.
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    May 22, 2010, 06:17 PM

    Does it run on heat?
    SM638's Avatar
    SM638 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    May 22, 2010, 07:17 PM

    No it does not
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #4

    May 22, 2010, 08:18 PM

    Most likely the motor is bad, or it could be a bad start capacitor
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #5

    May 22, 2010, 09:37 PM
    Have you got a setting on your tstat for fan/fan only? Does it work ? If not now go to the blower check to see if there is power going to the motor/by using a multimeter
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Luxaire furnace troubleshooting [ 1 Answers ]

Luxaire propane furnace.. 4yrs old. Following a power outage... the furnace pre blower comes on fan comes on but no heat. Furnace is flashing 3 flashes . Filter is clean and blower motor seems to work on fan. Any thoughts.. Thanks Greg

Luxaire furnace troubleshooting [ 2 Answers ]

My furnace manual says I can set the fan off delay on the PC board.my model has no such jumper that I can see.does the primary limit switch (open@140/close@100)control the blower? After gas shutoff the blower runs twice as long as I would like, sending cold air into the rooms.

Luxaire furnace troubleshooting [ 0 Answers ]

As far as I can tell I have an ignitor problem. Works intermittantly. Filter is clean, pre-blower activates appropriately and IF ingnitor comes on, then the gas ignites and all is well. Thoughts?

Luxaire furnace troubleshooting [ 1 Answers ]

I have a 2334 sg. Foot log home it has 2 3.50 ton units 1 of the units runs twice as much as the other.these are brand new units been in house less than year.Had the heat and air company back out to my house 4 times can't really tell me why they have closed down some vents at units didn't really...

Luxaire troubleshooting [ 0 Answers ]

Preasure switch stuck open how do you get it unstuck

View more questions Search