Ask Experts Questions for FREE Help !
Ask
    GregGowing's Avatar
    GregGowing Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Mar 30, 2012, 04:10 PM
    Keep rite furnace hi eff
    T-stat calls for heat, no inducer until I remove a wire off any limit. Than inducer turns on, but no hot surface. Checked continuity on all limits there all good I am stumped. Replaced mother board because of a ground short. I'm confused, any suggestions
    Greg
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Mar 30, 2012, 07:02 PM
    To me it sounds like your thermostat is wired wrong or is bad. You can wire R to W at the thermostat and see if the heat will work. If it works it's a bad thermostat or set up wrong. If it doesn't work you can use a wire and jumper R to W at the control board of the furnace if that works your thermostat wire is bad.
    GregGowing's Avatar
    GregGowing Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Mar 30, 2012, 09:33 PM
    All ready jumped r n w together and nothing, that's why I'm confused
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Hi Eff furnace continues to re-ignite [ 1 Answers ]

The burner of our Luxaire Deluxe High Efficiencey PBNU-LD12N080D relights several times during same continuous purge blower operation. Sequence is as follows: 1. Purge cycle. 2. Igniter burns. 3. Burner flame ignites. 4. Igniter goes out. 5. 10-15 seconds later flame goes out. 6. Igniter...

York 80% eff Heating furnace [ 1 Answers ]

I had a new YORK 80% furnace installed in Sep'10. Room Temp never reaches required or set temperature- goes up 2 degree and stops. Furnace Flashes red 6 times - "Pressure switch cycle lockout". I have to turn the Thermostat off and on again to restart. Otherwise, it waits for 1/2hr and so and...

Thermostat for a 2 stage hi-eff furnace [ 4 Answers ]

I have a conventional furnace running on a LUX500 4 wire thermostat. I know that the thermostat has a 24v AC supply to it and the digital display is b/u with battery. I am changing to a Lennox G61V hi -eff furnace with 2 stage heating and variable speed DC motor. I was told that I could continue to...

80% eff furnace [ 31 Answers ]

Can I convert an 80% eff furnace to a 100% eff? I have an older furnace that I want to put in a house but the house has no chimney. Any suggestions? Thanks Jeff

Carrier Hi Eff Furnace [ 6 Answers ]

I need to know the MBh for a 58UVB060, does anyone know?

View more questions Search