 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Leaking Shower/Bath Faucet. Replaced Stem, Assembly
Hello,
I have leaking in my bath/shower faucet. It is a Danco kit. I believe the original was Bradley-Cole. After removing the stem, my old one had a hole on the end rubber piece. So I was pretty confident replacing it would fix it. After replacing it a pretty hard stream went to completely fixed. Not even a drip was coming out. After about 2 days it has started to have a stream again. It's not a drip, but a fair stream. I shut off water again and removed it. I added some O-Ring lubricant on anything rubber to see if that would help. Not really. I don't see anything to tighten or anything. What should I try next? Could I need to change the spout? |
||||
Check out some similar questions!
I just spent 2 hours TRYING to replace a Peerless Soultions kitchen faucet stem , seat and springs. 1 blood blister and really aggrevated I have no leaks but no water either. And yes fellows I remembered to turn the water back on. The only way I can get the water to move is start removing the stem...
Replaced a american standard 11K-3H/C faucet stem and barrel. It is leaking. The valve opens (twist the handle to the left) but when twisting the handle to close and turn off water the handle will continually turn left does not stop.. any ideas?
I have recently replaced my faucet valve stems and the shower devirter stem in the bath tub, and now the only thing that water is flowing through is the shower head and not the spot going in the tub. Also the shower devirter only makes a 1/4 turn.
I replaced my Price Pfister shower valves, including diverter, and I cannot stop the slow drip from the spout into the tub. I am a novice DIY'er with an older 1930's triplex. There was no leak before with the previous valves but they were very old, tough to turn on/off, and had water temperature...
Hi, I recently replaced a bath faucet. I had to replace the entire pipe (Galv) and the hardware store did not have the proper length. I used a 48" threaded pipe with a coupler and a 4" nipple to get the proper size. When I turned the water back on, there is a leak at the coupler. I would use...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
