Check out some similar questions!
Carrier Model 58G5100-2
[ 0 Answers ]
I have a Carrier Model 58G5100-2 Series 201 gas furnace. It appears to have a squealing motor in the air handler caused by a loose belt. I'm ready to apply the belt dressing and replace it as needed. Simple question: Where is it and how do I access it? Can't get to it by removing the main access...
Carrier 58PAV not cycling
[ 4 Answers ]
Hello all, I purchased a home a few months ago with a Carrier 58PAV unit. The AC worked fine but I'm having a problem with the heating, it would not come on so I changed out the thermostat but quickly realized that was not the problem. If I turn on the thermostat and turn off the main switch on the...
Carrier furnace flame (only) cycling
[ 11 Answers ]
I have a Carrier 58GS furnace. It appears to be operating fine until I stood next to it. The gas flame comes on and off about every 5 seconds. This is not to be confused with short cycling. The blower is running as it should be and at the appropriate times. Thought before I dug into it, the...
Carrier 58ss cycling
[ 83 Answers ]
I had about the same problem last heating season. One repairman said it needed a new control board and then online I read about the pilot ignitor. I replaced stark electrode and pilot burner and it seemed to fix it. The it started again so since I bought the control board online previous, I put...
Carrier Furnace cycling on and off
[ 8 Answers ]
I have a Carrier 58DX-100-DC furnace that I have a problem with, The inducer motor will come on and run then the pilot will light and then the burner comes on and a couple minutes or less the blower comes on it will stay like this for about 2 or 3 minutes then the inducer motor stops and the gas... View more questions Search
Add your answer here.
|