Ask Experts Questions for FREE Help !
Ask
    JayGriffin's Avatar
    JayGriffin Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jun 29, 2010, 04:55 PM
    Draft inducer kicks on when on cool
    Goodman GMP075-3
    My thermosat is on cool. My fan is "on". My A/C is working. Strange thing is happening -- my draft inducer is kicking on periodically. RUns for about 10-15 seconds. Any ideas why this would be happening? Checked connections on wires -- everything seems to be plugged in snug. The light on the circuit board is solid red -- not blinking any error codes.

    Your help/input is appreciated!
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Jun 29, 2010, 05:17 PM

    Did your board get wet, or draw moisture? May need dryed out or a new control board.
    JayGriffin's Avatar
    JayGriffin Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jun 30, 2010, 11:24 AM
    No. We did have some water (less than 1/2 inch) in our basement about 3-4 years ago, but nothing recently. But you are the 2nd person who said it is probably the control board. Thanks for your help.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Draft inducer troubleshooting [ 3 Answers ]

I have a 5 yr. old dunkirk xeb3 boiler. This year on starting I noticed a smell of burnt gas coming out from around the draft inducer housing. I checked housing and gasket, both seemed fine. Fan only runs for approx. 5 seconds before ignition, and shuts off right after flame stops. Could this be...

Draft inducer does not start [ 1 Answers ]

...

The Power Venter (aka Heat Inducer and Draft Inducer) will not start on Goodman. [ 8 Answers ]

FURNACE: Made by: Goodman Model #: GMPN080-4 THE POWER VENTER (this is what the Goodman manual calls it but other websites refer to this as the Heat or Draft Inducer): Made by: FASCO Industries 70219565 Type: U218 Volts: 115 RPM3400 Customer Part #: B2833001S

Draft inducer humming [ 1 Answers ]

The draft inducer on my furnice is stuck or something, it makes a humming noise for an extended period before the heat kicks on. The blower, the heat ignition everything is fine. It also seems like it starts too frequently.

No voltage to my draft inducer [ 3 Answers ]

I have a Janitrol Furnace that will not start up. I pulled of the tube from the draft inducer to the pressure switch. I sucked on the tube and the furnace fired up. So I checked the voltage going to the draft inducer, it read only 6v ac. Where do I go from here?

View more questions Search