Ask Experts Questions for FREE Help !
Ask
    buterfly1964's Avatar
    buterfly1964 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 12, 2009, 10:46 AM
    Draft inducer humming
    The draft inducer on my furnice is stuck or something, it makes a humming noise for an extended period before the heat kicks on. The blower, the heat ignition everything is fine. It also seems like it starts too frequently.
    WallyHelps's Avatar
    WallyHelps Posts: 1,018, Reputation: 136
    Ultra Member
    		  
    #2

    Oct 12, 2009, 05:44 PM

    Does the inducer motor run at all? If not, see if it will run by giving it a nudge while it is humming (should be an arrow showing proper rotation) and see if it starts running. If it does, it could mean that the bearings are gummed up or there is some other obstruction in the motor.

    Good luck,
    WallyH
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Inducer (Draft) Motor constantly on - Lennox UHG80-100 [ 3 Answers ]

My furnace's draft motor never stops even after one full heating cycle, which it's supposed to stop! This causes the pressure switch to stay closed even after the thermostat calls for heat the second time (after the initial heat cycle). When I stop and start the main switch in my basement,...

Installation Procedures for draft inducer on Goodman [ 3 Answers ]

My HVAC contractor identified that the draft inducer motor had seized on my Goodman furnace (this after he just replaced the blower motor this past April). I researched the replacement part after he gave me a quote and I would like to avoid his supplier's markup on the replacement motor, and...

The Power Venter (aka Heat Inducer and Draft Inducer) will not start on Goodman. [ 8 Answers ]

FURNACE: Made by: Goodman Model #: GMPN080-4 THE POWER VENTER (this is what the Goodman manual calls it but other websites refer to this as the Heat or Draft Inducer): Made by: FASCO Industries 70219565 Type: U218 Volts: 115 RPM3400 Customer Part #: B2833001S

Forced hot air issue (Draft inducer fan) [ 1 Answers ]

My draft inducer fan is running for about 3 minutes before the furnace ignites. Once it ignites,the furnace is operating correctly. This seems to be longer than normal. Any ideas on what's wrong, or what I need to check/test? Thanks!

No voltage to my draft inducer [ 3 Answers ]

I have a Janitrol Furnace that will not start up. I pulled of the tube from the draft inducer to the pressure switch. I sucked on the tube and the furnace fired up. So I checked the voltage going to the draft inducer, it read only 6v ac. Where do I go from here?

View more questions Search