Ask Experts Questions for FREE Help !
Ask
    kenmic's Avatar
    kenmic Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Nov 23, 2006, 08:41 AM
    Bryant ceiling mount furnace
    :confused: thank you but I think you misunderstood,the fan(blower) remains on entire time.the fire(burners) are turning on and off in a matter of minutes,approximately 3 min. cycles. Is there a switch like the blower switch for the flame? Or is this stemming from the regulator somehow. I know the gas is being shut off just not sure of source of signal thanks again for you time mike
    NorthernHeat's Avatar
    NorthernHeat Posts: 1,455, Reputation: 132
    Ultra Member
    		  
    #2

    Nov 24, 2006, 12:03 PM
    Sounds like it could be a bad flame sensor or auto pilot which ever that furnace has
    labman's Avatar
    labman Posts: 10,580, Reputation: 551
    Uber Member
    		  
    #3

    Nov 24, 2006, 12:55 PM
    Adding some details. If a bad switch is sending a false signal, the controls will keep the blower going and keep trying to restart the burner. Fix the problem with the switch as Northern Heat said, and the furnace will work.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant furnace problem [ 20 Answers ]

Hi All, I have a 5 y/o 80% eff bryant furnace. The problem I have is that my furnace Doesn't always kick on even when thew thermostat shows the temp under the Temp set. I will sometimes have to go down and turn of the blower switch on the furnace wait a couple seconds and then turn it on again....

Bryant furnace won't lite [ 3 Answers ]

Hello, I have a Bryant furnace. It Keeps flashing code 13 on the circuit board. I read the code and it says that the switch will reset after 3 hours. It also refers me to # 33 which gives more possibilities as to what the problem may be. However it does say to reset the limit or flame roll out...

Bryant ceiling mount furnace [ 1 Answers ]

:confused: thank you for your quick response, upon receiving your reply I was a bit more bewildered. I went to run it through a cycle and watched entirety.I am under the impression the fan is working properly(may be kicking on a bit early)the new problem I noticed is the burners run initially for...

Bryant ceiling mount furnace [ 1 Answers ]

:confused: hello, I recently bought a used bryant ceiling mount furnace model#125-341,not sure of man. Date but guessing older vintage. I went through completely and cleaned thoroughly,mounted and fired it up. Pilot stays lit fine,fan kicks on right away?before the burners ignite. Am getting nice...

Bryant upflow furnace model394g lp [ 1 Answers ]

How do you adjust pilot light?

View more questions Search