 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Bryant ceiling mount furnace
:confused: thank you for your quick response, upon receiving your reply I was a bit more bewildered. I went to run it through a cycle and watched entirety.I am under the impression the fan is working properly(may be kicking on a bit early)the new problem I noticed is the burners run initially for about 3 minutes then shut off for about same amount of time. It appears to repeat this cycle which is why I thought flame was out of adjustment. Fan is basically blowing cold air, I didn't notice this first time, because I must have walked away before burners went out and when I checked it because of the slow warm up it was on a burn cycle again. This is a older(probably 20 yrs. Or better) bryant ceiling mount furnace model #125 341. Thank you in advance for any help. Mike
|
||||
|
||||
|
If your furnace has a fan switch it works this way: the fire comes on and the fan switch, which is set to come on at a certain temp, reacts to the heat and starts blowing, as soon as the temp of the air going by the fan switch is lower than the setting the fan stops till it is warmed again by the burners. If the room that this heater is in is very cold when your furnaces starts to operate then it is normal for the blower to turn on and off several times before the air is warm enough to not turn off the fan.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Hi All, I have a 5 y/o 80% eff bryant furnace. The problem I have is that my furnace Doesn't always kick on even when thew thermostat shows the temp under the Temp set. I will sometimes have to go down and turn of the blower switch on the furnace wait a couple seconds and then turn it on again....
I purchased a new Bryant 2 Stage furnace last year and it now makes a rumbling / vibration noise when the furnace kicks into the second stage. It seems like it does this when the furnace gets a lot of use. For instance, Today it turned on once or twice and no rumbling/vibration noise. However,...
Hello, I have a Bryant furnace. It Keeps flashing code 13 on the circuit board. I read the code and it says that the switch will reset after 3 hours. It also refers me to # 33 which gives more possibilities as to what the problem may be. However it does say to reset the limit or flame roll out...
:confused: hello, I recently bought a used bryant ceiling mount furnace model#125-341,not sure of man. Date but guessing older vintage. I went through completely and cleaned thoroughly,mounted and fired it up. Pilot stays lit fine,fan kicks on right away?before the burners ignite. Am getting nice...
How do you adjust pilot light?
View more questions Search
|
