Ask Experts Questions for FREE Help !
Ask
    riverfall's Avatar
    riverfall Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 15, 2006, 11:59 AM
    Bryant upflow furnace model394g lp
    How do you adjust pilot light?
    NorthernHeat's Avatar
    NorthernHeat Posts: 1,455, Reputation: 132
    Ultra Member
    		  
    #2

    Oct 15, 2006, 01:41 PM
    Why do you want to adjust the pilot? The majority of the time it will never need readjusted. If the pilot is suddenly weeak the pilot assembly and orice in it need cleaned. There are two adjustments on the gas valve, one is the output gas pressure, the other is the pilot adjust. The pilot adust is covered by a screw about 1/2" long and requires a narrow standard screwdriver to adjust, don't adjust the wrong one. The pressure regulator srew is much wider.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant furnace problem [ 20 Answers ]

Hi All, I have a 5 y/o 80% eff bryant furnace. The problem I have is that my furnace Doesn't always kick on even when thew thermostat shows the temp under the Temp set. I will sometimes have to go down and turn of the blower switch on the furnace wait a couple seconds and then turn it on again....

New Bryant furnace makes a rumbling noise [ 6 Answers ]

I purchased a new Bryant 2 Stage furnace last year and it now makes a rumbling / vibration noise when the furnace kicks into the second stage. It seems like it does this when the furnace gets a lot of use. For instance, Today it turned on once or twice and no rumbling/vibration noise. However,...

Bryant furnace won't lite [ 3 Answers ]

Hello, I have a Bryant furnace. It Keeps flashing code 13 on the circuit board. I read the code and it says that the switch will reset after 3 hours. It also refers me to # 33 which gives more possibilities as to what the problem may be. However it does say to reset the limit or flame roll out...

New Bryant A/C compessor will not run [ 1 Answers ]

I have a newly installed Bryant 2 1/2 ton compressor unit that was installed in August 2005. When I turned on the A/C the unit would not start. I checked the disconnect near the compressor and found it to be faulty and replaced it with a new one and there is still no start up. I pulled the panel to...

View more questions Search