Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bryant furnace problem
[ 20 Answers ]
Hi All, I have a 5 y/o 80% eff bryant furnace. The problem I have is that my furnace Doesn't always kick on even when thew thermostat shows the temp under the Temp set. I will sometimes have to go down and turn of the blower switch on the furnace wait a couple seconds and then turn it on again....
Lite On Combo Drive
[ 1 Answers ]
Having trouble finding the drivers for a Lite On Combo LTC-48161H dvd/rw drive.According to various Googling I've done,the driver download sites on the net,are either incomprehensible,or don't work.Even the manufacturers site does a 404! In other words,as things stand,the combo-drive does zip,and...
New Bryant A/C compessor will not run
[ 1 Answers ]
I have a newly installed Bryant 2 1/2 ton compressor unit that was installed in August 2005. When I turned on the A/C the unit would not start. I checked the disconnect near the compressor and found it to be faulty and replaced it with a new one and there is still no start up. I pulled the panel to...
Faulty lite
[ 3 Answers ]
:confused: I recently installed a flouresent lite fixture and after being on for ten or fifteen minutes, it shuts off. Is the ballast bad or something else going on? Thank-jb.
Gas Furnace Doesn't Lite
[ 3 Answers ]
My Carrier Furnace Igniter glows but the valve won't turn the gas on. I have discovered that the relay switch on the top of the valve has a bad connection to the pins (2 each) on the two solenoids. I can loosen this and slide up and down several times and it will work for awhile. My problem is that... View more questions Search
|