Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How to safely wire aluminum to copper wire
[ 5 Answers ]
I am switching a non-programmable t-stat to a Honeywell 5-2day programmable one that is for baseboard, covectors and fan-forced heaters. The model number is RLV430A. I have a wall Cadet heater so it should be OK. Problem is when I opened the package the wiring on the t-stat is aluminum. ...
50 amp gauge copper wire
[ 2 Answers ]
I am running a electrical circuit to a range that requires 50 amp serv I have run my conduit is it OK to use #6 thhn for power and#10thhn for my neutral or ground I was told I could use one gauge lighter for grounds and neutrals??
Attaching Copper wire to alum. Wire in fuse box.
[ 1 Answers ]
I have a electric stove to hook up in my house that had a gas stove. The electric 50 amp receptacle is already in place from the previous owner. The existing stove “aluminum” wiring goes into the circuit breaker box, but the wiring is cut off inside the circuit breaker box and is too short to...
Copper Wire to Silver Wire
[ 2 Answers ]
I recently purchased a replacement flush ceiling fixture. The black and white wires coming from my electrical box in the ceiling are copper colored, the black and white wires in the new fixture have a silver colored wire. Is it OK to connect them?
Copper wire standard, UEW
[ 2 Answers ]
I would like to ask if any expert knows anything about a kind of copper wire standard, UEW. I'd like to know what it is about? And where can I have more information on it? Thanks a lot! View more questions Search
|