 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Grounding a 320 amp service
I have a 320 amp service I have my meter mounted on a pedestal by my house with 2 disconnects on the right side. I have 2 200 amp boxes in my house in different locations. I was wondering how I would ground my disconnects outside and if I had to ground or bond my 200 amp boxes inside and how
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have a 200 amp meter on a power company pole in the country for barn electricity. I have built a small shed 285' away and want 100 amp service. Based on the distance, I am planning on using 4/0 4/0 2/0 Al URD cable in 2" conduit buried 24". To get the lug sizes to fit the 4/0, I am using 200...
For a 200 amp 2 family overhead service I am using a primary and a secondary ground. A #6 stranded copper to two ground rods and a #4 stranded copper to the water meter. My question is, do I run the ground wires to the meter bank or to the panels? I believe it is the meter bank but just want to...
The means for grounding a 200amp delta service enterance panal? The grounded and the grounding are on the same bus bar, Where should I ground my grounding rod & #6 bare grounding wire?
I have a 200 amp 2 family meter pan, with 2 100amp panels located in the basement right behind the meters. If I run a #6 stranded ground wire to 2 ground rods and hook it up in one of the panels and install a jumper to the other panel, and run a #4 to the water main and hook it up at the meter pan,...
How to ground 400 amp service with 2 200 amp panels one on disconnect switch
View more questions Search
|
