Ask Experts Questions for FREE Help !
Ask
    cwalthall's Avatar
    cwalthall Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 6, 2008, 01:56 PM
    Craftman LT2000 - 917.255751
    My 3 year old LT2000 will only run 10 minutes and shut off. I replaced the spark plug, gas filter, air filter and oil filter. Does anyone know the cause of this problem?

    Thanks Carl
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
    		  
    #2

    Jul 7, 2008, 02:57 PM
    Could be the coil going bad.
    Could also be the gas cap vent stopped up.
    Will it restart after it dies, or do you have to let it set for awhile?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Sears Craftman LT2000 Model - 917 273130 Belt Placement [ 3 Answers ]

I have Sears Craftman LT2000 Model - 917 273130 I need to replace the belt and need a diagram to show how to install the new belt I purchased.

Craftman LT2000 - 917.255751 [ 2 Answers ]

I have had my craftsman lt2000 for 2 years it runs fine and drives, but at the end of last year you had to jiggle to the mower deck to get the blades to engage once the lever was set to mow. This year the mower deck does not engage when you engage the lever it pulls a cable that goes taught and...

Sears LT2000 Clutch [ 1 Answers ]

Got a Sears LT2000 Lawn Tractor when the kids moved to town replacing my trusty mtd 38inch tractor. Be that as it may I find the clutch to be very tight in that when releasing the pressure on the pedal the mower jerks and does not have the range or finesse to gradually go up a hill where I need...

Drive belt on craftsman lt2000 [ 1 Answers ]

How do I put the belt back on? Took out the battery and holder to get to pulley, have clutch disengaged (locked) and cannot get enough slack to put belt on?

Pulley won't release on LT2000 [ 1 Answers ]

I was wondering if anyone knows which pulley is supposed to give when I change a deck belt on a Craftsman LT2000. I took the other one off and have the new one on except I can't find which one of the 5 pulleys should be giving for the final belt to go over. I wouldn't think it would be any of the 3...

View more questions Search