Ask Experts Questions for FREE Help !
Ask
    bhbhbh's Avatar
    bhbhbh Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 1, 2007, 05:46 PM
    Pulley won't release on LT2000
    I was wondering if anyone knows which pulley is supposed to give when I change a deck belt on a Craftsman LT2000. I took the other one off and have the new one on except I can't find which one of the 5 pulleys should be giving for the final belt to go over. I wouldn't think it would be any of the 3 outside ones, but I just don't know, I also lost my manual like a dummy. Thanks to anyone that can help... BH
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Apr 1, 2007, 06:57 PM
    I've got an LT1000 so hopefully they are similar. You probably have three blades and you can tell which pulley is attached to the blades. The other two pulleys are an idler and a tensioner. The tensioner is spring loaded and can be moved.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Release to another state from Iowa work release [ 5 Answers ]

My dad put in a transfer to Florida as he is in Iowa work release about a month ago, how long should it take? I can't wait to see him... They said Des Moines already approved it... Please help Sheena:confused:

B&s 14.5 HP - Drive Pulley [ 1 Answers ]

The keyway is gone, when I try to loosen the bolt, the engine turns. How do you remove the bolt in question when you do not have impact tools available?

Changing Engine Pulley? [ 5 Answers ]

I have Sears riding Lawn Mower with Brides & Stratton engine and it's engine pulley broke off. There are two pulleys attached to this shaft. How to remove and replace this shaft? It's attached to the engine. Thanks.

Sears LT2000 Transmission Problem [ 2 Answers ]

I have a Sears LT 2000 17HP Kohler Engine & the manual 6 Speed Trans. SHifter. I had to stand the mower up to put a new tie rod on one of the front tires and after that no matter what gear you put it in it is like it is in neutral. I lifted it again and tried looking to see if something...

Removing MTD engine pulley [ 3 Answers ]

I need to replace my drive belt but cannot get the pulley off, motor spins? Any suggestions? Also it is reverse thread correct? Thank You

View more questions Search