Ask Experts Questions for FREE Help !
Ask
    Steve1445's Avatar
    Steve1445 Posts: 2, Reputation: 1
    New Member
     
    #1

    Mar 9, 2008, 06:48 AM
    Toilet Vent
    While taking out a bathtub I discovered a vent for the toilet. Looks like it runs straight up to an attic space (not a sealed space, outside air passes through at will) and not through the roof to the outside. The wall that it is in is perpendicular to the main wall to the room and I would like to reduce this wall to a half wall. My question is: does the vent have to go straight up, or can I put a 90 degree bend and reroute it to another attic (sealed space) behind the main wall of this room. And, is there a minimum height for the vent that I have to watch out for. There is also a main vent for the bathroom and laundry about 9 feet from (downstream) this newly discovered toilet vent.
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
     
    #2

    Mar 9, 2008, 07:08 AM
    Hi Steve.

    The vent does not have to run straight up... so a 90 degree turn over and then another 90 degree turn up will be fine.

    Code says that that vent needs to tie into the main vent just before it penetrates the roof.. or exit the roof by itself.

    Hope that answered your question... MARK

    If this helped, please RATE THIS ANSWER. Thnak you.


    .
    Steve1445's Avatar
    Steve1445 Posts: 2, Reputation: 1
    New Member
     
    #3

    Mar 10, 2008, 03:45 AM
    Quote Originally Posted by massplumber2008
    Hi Steve.

    The vent does not have to run straight up...so a 90 degree turn over and then another 90 degree turn up will be fine.

    Code says that that vent needs to tie into the main vent just before it penetrates the roof..or exit the roof by itself.

    Hope that answered your question...MARK

    If this helped, please RATE THIS ANSWER. Thank you.


    .
    Thanks Mark, just the info I needed. Steve

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How far can toilet be from vent [ 1 Answers ]

Hi I am getting ready to finish my downstairs,it was already plumbed for the bathroom under the concrete. The problem is I need to move everything to finish the room the best way. Which means I need to move the toilet about 5' against a cement wall. So was wondering if I just move the pipe in the...

Toilet Vent [ 1 Answers ]

Hello, I live in Atlanta, Georgia and I need to pass my plumbing inspection on a finished basement bathroom. My toilet discharges into my pump which is vented to the outside. My question is: Do I need to have a separate studor vent for the toilet? Thanks for your assistance!

Toilet Vent [ 1 Answers ]

A house requires one 3" main vent. On new construction we usually make this vent the kitchen sink vent6. The rest can be 2". You have a major fixture discharging past two unvented minor ones. Both the shower and the tub will have to be vented individually, the vents will have to be installed Just...

Toilet Vent [ 3 Answers ]

After removing my toilet, I see that it has two openings, a 3" opening in the front (connects to the main drain) and there is a smaller opening in the back for venting. Is it a 90 degree heel elbow used upside down? Should this be corrected?

Toilet Vent [ 5 Answers ]

I am putting in a septic system at my cabin, there is a toilet in the bathroom that will need to be tied to this new septic system. The toilet has a 4" pipe that runs through the crawl space, under the footings and is stubbed outside the cabin. This pipe is a straight pipe with total of about 13'...


View more questions Search