Ask Experts Questions for FREE Help !
Ask
    thermo2's Avatar
    thermo2 Posts: 2, Reputation: 1
    New Member
     
    #1

    Apr 14, 2008, 08:25 PM
    New thermostat air not working
    I hooked up my new honeywell RTH230B thermostat and the heat seems to be working, but the airconditioning won't come on. I hooked the W to the W, the Y to the Y, the G to the G, the R to the Rh and the C to the Rc. At first I tried it without the jumper between Rh and Rc because that's what it said in the instructions, but I also tried it with and it still didn't work. Any suggestions?
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
     
    #2

    Apr 14, 2008, 09:28 PM
    C is a newcomer to the thermostats. It wasn't required on the older ones. It is required when the thermostat does not relay on batteries for the primary power. C has to come from the opposite end of the transformer that R was connected too.

    You need to run a wire for C.
    Rc gets connected to Rh which gets connected to R. c and h refer to heat and cool. Using Rh and Rc accommodates two transformer systems.

    The reason why your heat appears to work is probably because of some backfeeding of power.
    thermo2's Avatar
    thermo2 Posts: 2, Reputation: 1
    New Member
     
    #3

    Apr 15, 2008, 06:11 PM
    I unhooked the C wire, hooked R to Rh and jumped Rh to Rc. Now neither heat or cool is working. Could I have blown out a fuse or messed up my thermostat by hooking it up wrong to begin with?
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
     
    #4

    Apr 15, 2008, 07:10 PM
    C was on the old stat. I missed that. Saw it after I looked up the instructions. (C) needs to be taped so it doesn't hit anything.

    Some furnaces have fuses on the control transformer. Others do not. You could have damaged either new stat or transformer.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Thermostat not working [ 2 Answers ]

I have a maple-chase thermostat #09600 (programmable) that will not operate. It was working fine until a spark of static electricity from my finger to the unit caused it to malfunction. I tried pushing the reset button but no luck. I have researched the manual but cannot find anything that...

Is thermostat working properly? [ 3 Answers ]

During the cycling of a furnace, how long should it be off and how long should it run? Thanks,

My furnace or thermostat is not working [ 1 Answers ]

I have a honeywell RTH230B thermostat and my furnace is a carrier. Now the red light at the bottom of the furnace is on all the time when it works but then it will stop working and the red light will blink one short 4 long witch means it's a lockout. Now why does it do that and what do I need to...

Thermostat not working [ 1 Answers ]

My ceiling heat won't shut off when I turn down the thermostat. How do I find out if the thermostat is broken?


View more questions Search