Ask Experts Questions for FREE Help !
Ask
    rcacka46's Avatar
    rcacka46 Posts: 4, Reputation: 1
    New Member
     
    #1

    Feb 11, 2008, 07:29 PM
    B&S 15 HP mower engine
    Hi all, I was given a Bolens riding mower with a 15 HP Briggs engine on it, the mower had been sitting a while outdoors so I changed the oil, the fuel filter, and cleaned the carb and replaced the battery, when I started it up it would run and then stop and run and then stop. Then it ran for 10 minutes but was blowing white smoke and oil out the exhaust. I think I have blow by but not sure so I am asking the question would I have to rebuild the engine?
    Robert
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #2

    Feb 12, 2008, 11:02 AM
    You may have a stuck valve that isn't closing completely. Can you do a compression check?
    rcacka46's Avatar
    rcacka46 Posts: 4, Reputation: 1
    New Member
     
    #3

    Feb 15, 2008, 04:59 PM
    It is getting compression, if it is a valve, does anybody have the torque specs for the valves?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #4

    Feb 17, 2008, 09:48 AM
    Torque specs or gap? I torque a head but gap a valve.
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
     
    #5

    Feb 17, 2008, 04:18 PM
    Are you by chance getting oil in the air cleaner housing, if so, replace the breather assembly.
    rcacka46's Avatar
    rcacka46 Posts: 4, Reputation: 1
    New Member
     
    #6

    Feb 17, 2008, 04:20 PM
    The gap for the valve and then the torque specs for the head bolts since I need to remove the head to clean the valves and reinstall it.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

12.5 HP Briggs & Stratten Lawn Mower Engine [ 2 Answers ]

Hi- I have a strange problem with this engine. It starts and runs fine most of the time. But, every now and then it starts to smoke, lots of smoke out the muffler. The only way I can get it to stop is turn the engine off. It get into the carburetor through the Positive crankcase ventilator. I...

Briggs & Stratton 10 hp lawn mower engine? [ 1 Answers ]

Just wondering if the flywheel should be in contact with the starter at all times as it appears to be! It has eaten the flywheel gear off! Stupid nylon gear! Is there any after market alloy type replacement? Numbers off engine plate Model 28a707 Type 0113-01 Code 951103za

Frozen lawn mower engine. [ 8 Answers ]

My lawn mower has been resting for several months.Now that I have tried to start it, it will barely turn. Is there some way I can unfreeze the engine without taking it apart? Thanks, ...

Murray Mower with Q4.5B/S Engine [ 1 Answers ]

My mower surges and slows almost to stopping. Spark plug is new,oil changed and new air cleaner element.Fuel in tank is fresh and clean. There is no adjustments to be made to carberator. Old plug was fouled when removed. What should I do now? Remove carberator and check pick up to see if it is...

Ride on mower engine problem [ 3 Answers ]

Hi, I have a ride on Snapper mower powered by a 14HP Briggs & Stratton engine. Model 287707, Type 023501 Code 9601084A I can start the engine with the choke engaged and it will run. But when I take it off choke the engine stalls. Do you have any idea what the possible causes could be....


View more questions Search