Ask Experts Questions for FREE Help !
Ask
    Hol's Avatar
    Hol Posts: 41, Reputation: 1
    Junior Member
    		  
    #1

    Nov 28, 2007, 09:58 PM
    Latch system?
    Hi I was wondering if anyone could help I was searching the web and didn't come up with any answers I have a 2000 jeep grand cherokee laredo and I was wondering if anyone knew if it had the latch system for the car seat? And were would I find it. I was looking today but I wasn't sure were to look so I didn't find it. If anyone could help please do thanks
    J_9's Avatar
    J_9 Posts: 40,298, Reputation: 5646
    Expert
    		  
    #2

    Nov 28, 2007, 09:59 PM
    Latch system? Can you please get a little more detailed? Do you mean where you can control it so that the doors do not open from the inside?
    Hol's Avatar
    Hol Posts: 41, Reputation: 1
    Junior Member
    		  
    #3

    Nov 29, 2007, 07:28 AM
    No I'm talking about the latch syster or tether not sure what everyone calls it but it to connect the carseat without using the seatbelt..
    J_9's Avatar
    J_9 Posts: 40,298, Reputation: 5646
    Expert
    		  
    #4

    Nov 29, 2007, 04:46 PM
    Some vehicles have them yet others don't. I have a 5-point harness seat for my youngster and the latch is above the backseat (I drive a 2006 Ford Five Hundred), in between the seat and the back there are two little bars where the carseat attaches directly to the frame of the vehicle.

    You do still need to use the seat belt though. It provides much more protection.
    Hol's Avatar
    Hol Posts: 41, Reputation: 1
    Junior Member
    		  
    #5

    Nov 29, 2007, 04:54 PM
    I will use the seat belt too but I was reading a lot of stories about the seat belt uncliping durning a accident then the baby gets hurt so I wanted to use both so just in case that ever happened thanks a lot I will check for it
    J_9's Avatar
    J_9 Posts: 40,298, Reputation: 5646
    Expert
    		  
    #6

    Nov 29, 2007, 05:04 PM
    Yeah, that's what I do too. I don't know that a jeep cherokee would have this though as the tether behind the seat clips into the frame of the vehicle also. That tether is above the seat, below the back window, in MY car.

    You could try calling your local Jeep dealer.
    Hol's Avatar
    Hol Posts: 41, Reputation: 1
    Junior Member
    		  
    #7

    Nov 29, 2007, 09:40 PM
    Thanks a lot
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

System calling for heat but no response from system [ 1 Answers ]

My thermostat is set to 25 which is higher than the current temperature but my heating system is not firing up.. we have hot water - the boiler is a Micron - the heating timer is set to "on" on the program setting, and so is hot water which is fine but we have no heating, it was on earlier and went...

Smoke extract system & staircase press. System [ 2 Answers ]

I am working for a 35 storey tower. There are smoke extract and staircase/lift lobby pressurisation system in case of fire. Now consultant has already given the CFM required for these Fans, but I have to submit the calculations for the same to the Local Govt. authority. So please help me if...

Oven latch won't allow door to shut [ 1 Answers ]

I have a GE electric stove. My daughter tried to auto-clean the oven she moved the latch from left to right and started the cleaning cycle. Then later during the cycle decided she needed the oven she shut the switch off but did not wait for the oven to cool before using a screwdriver to force open...

Latch Key Kids Safety [ 3 Answers ]

I am a computer programmer and I am looking for feedback from parents. I am considering developing a Home Alone monitoring system for Latch Key Kids. The system would monitor the house for access/exits, smoke, power outage and the child via safety verification entries. I am looking for input...

How do I increase H2O pressure on well system with a water filtration system? [ 2 Answers ]

Howdy, I would like to know how I can increase my water pressure. My current system uses a well pump with a small pressure tank, and "D" control valve. It then runs through a WATERSOFT filtration tank, RAINSOFT water softner, and on the Hot water side, an AQUASTAR on demand hot water system. I...

View more questions Search