Ask Experts Questions for FREE Help !
Ask
    mamapook's Avatar
    mamapook Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 26, 2007, 03:05 PM
    System calling for heat but no response from system
    My thermostat is set to 25 which is higher than the current temperature but my heating system is not firing up.. we have hot water - the boiler is a Micron - the heating timer is set to "on" on the program setting, and so is hot water which is fine but we have no heating, it was on earlier and went off and we can't get it to come back on again, we've even tried turning thermostat to 30 and even though it clicks to suggest the temperature level it still does not fire up the heating.. please help we will be very cold!
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Oct 27, 2007, 07:56 AM
    Best bet for that unit is to call for service. There are no used serviceable parts to adjust just replace. This unit is somewhat complex for the homeowner to work on. You might try to turn the heat timmer off but that is about the most you can do.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue. [ 11 Answers ]

I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -

Smoke extract system & staircase press. System [ 2 Answers ]

I am working for a 35 storey tower. There are smoke extract and staircase/lift lobby pressurisation system in case of fire. Now consultant has already given the CFM required for these Fans, but I have to submit the calculations for the same to the Local Govt. authority. So please help me if...

Heil Furnace - No response when calling for heat [ 3 Answers ]

I have a 5 year old 90% efficient Heil Furnace. I get no response when I call for heat. (the "blower only" setting works fine.) I have confirmed that it is not the thermostat and that the fan control board has power. The gas valve light pulsates to indicate that it is OK. The lead that goes to the...

5 Wire 24v AC/Heat System [ 3 Answers ]

Hi, I bought a home. Had no thermostat. Putting in Honeywell CT3500 Programmable. Have Red, Green, Yellow, Blue, White. AC works but no heat. Thermostat came with R jumpered to Rc. How do I wire this to get AC and heat? Thank you. I need to also explain that I did put the appropriate wires...

How do I increase H2O pressure on well system with a water filtration system? [ 2 Answers ]

Howdy, I would like to know how I can increase my water pressure. My current system uses a well pump with a small pressure tank, and "D" control valve. It then runs through a WATERSOFT filtration tank, RAINSOFT water softner, and on the Hot water side, an AQUASTAR on demand hot water system. I...

View more questions Search