Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Trane XL80 TUD100R948K furnace
[ 4 Answers ]
I have a Trane XL80 2 stage furnace just installed and in the manual it mentions that the blower motor speed can be adjusted by the spped taps wiring. It has 4 wires black, yello, red and blue. And there is a terminal called "PARK". Which has the yellow wire connected to it and then RED to LO HEAT...
Trane XL80 Heater Unit
[ 4 Answers ]
We had a Trane XL80 Heater and XL 12 AC Condenser installed back in Jun 2004 - The blower fan on the heater is starting to make some noise! Not sure if it's getting ready to go out? Or not - also we had a Sta-Med Electronic Air Cleaner installed at the same time - the power light (green) does not...
Trane XL80 Can't Maintain Flame
[ 4 Answers ]
I have a Trane XL80 furnace. Basically, when it receives a call for heat, it ignites but cannot maintain the flame. As soon as the flame ignites (or within 10 seconds), it cuts off the gas flow and starts the ignition process again. It does this until the furnace locks out. Sometimes (probably 10%...
Trane Xl80 Furnace
[ 1 Answers ]
Hi, Keep getting the blinking light on the control panel. Flashes 4 times it say's it means that the thermal protection device is open. O.K. what does that mean . And can I fix or do I have to call a repair man Thanks Jimmyd View more questions Search
|