Ask Experts Questions for FREE Help !
Ask
    infieri's Avatar
    infieri Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 29, 2007, 10:21 AM
    Trane XL80 upgrade to 90K
    I have a Trane XL80 60K furnace with no air conditioning. It is about 15 years old. I want to upgrade the furnace to a 90K which I remember was supposed to be easy to do by simply replacing the jets with larger 90k units. But now the furnace installation company (original factory approved installer) says they never heard of such a thing. We bought this 60K unit only because we knew it could be "converted" to a 90K inexpensively, because we knew we were going to remodel in the future. We are now building the second addition since installation and are going to add the air conditioning unit and the heat pump for it, but we also need more heat for these cold Ohio winters. Do you know anything about the upgradability of this furnace? Thanks. Bob.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Nov 29, 2007, 02:00 PM
    Go with a new bigger furnace. Your old unit is 15 years ols already and getting close to replacement time anyway. You could also use a bigger unit because you will need more blower capacity for the new addition and now would be a good time to rethink all of your HVAC needs.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trane XL80 TUD100R948K furnace [ 4 Answers ]

I have a Trane XL80 2 stage furnace just installed and in the manual it mentions that the blower motor speed can be adjusted by the spped taps wiring. It has 4 wires black, yello, red and blue. And there is a terminal called "PARK". Which has the yellow wire connected to it and then RED to LO HEAT...

Trane XL80 Heater Unit [ 4 Answers ]

We had a Trane XL80 Heater and XL 12 AC Condenser installed back in Jun 2004 - The blower fan on the heater is starting to make some noise! Not sure if it's getting ready to go out? Or not - also we had a Sta-Med Electronic Air Cleaner installed at the same time - the power light (green) does not...

Trane XL80 Can't Maintain Flame [ 4 Answers ]

I have a Trane XL80 furnace. Basically, when it receives a call for heat, it ignites but cannot maintain the flame. As soon as the flame ignites (or within 10 seconds), it cuts off the gas flow and starts the ignition process again. It does this until the furnace locks out. Sometimes (probably 10%...

Trane Xl80 Furnace [ 1 Answers ]

Hi, Keep getting the blinking light on the control panel. Flashes 4 times it say's it means that the thermal protection device is open. O.K. what does that mean . And can I fix or do I have to call a repair man Thanks Jimmyd


View more questions Search