Ask Experts Questions for FREE Help !
Ask
    Phlat4's Avatar
    Phlat4 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jul 23, 2007, 05:18 PM
    Measuring for Sub-Rough positioning of traps and Bends
    Hi,

    Can the experts shed some light on how the locations of traps or closet bends are located for sub-rough
    Trenching/placement under a slab. Trying to visualize how these measurments are determined if there are no solid reference points other than maybe lines stung from corner to corner. Seems the measurements would have to be very accurate for slab to be poured or is the solution to use flex pipe box framed into the approximate location for adjusting +/- 1 or 2" after the slab is poured ? Appreciate any enlightment.

    Thx,
    Tracy
    iamgrowler's Avatar
    iamgrowler Posts: 1,421, Reputation: 110
    Ultra Member
     
    #2

    Jul 23, 2007, 06:19 PM
    Quote Originally Posted by Phlat4
    Hi,

    Can the experts shed some light on how the locations of traps or closet bends are located for sub-rough
    trenching/placement under a slab. Trying to visualize how these measurments are determined if there are no solid reference points other than maybe lines stung from corner to corner. Seems the measurements would have to be very accurate for slab to be poured or is the solution to use flex pipe box framed into the approximate location for adjusting +/- 1 or 2" after the slab is poured ? Appreciate any enlightment.

    Thx,
    Tracy
    Stringing control lines that represent the position of the framing is the only way I'll even start the ground work phase of a Plumbing job.

    If the contractor is unsure of the wall layouts, then I pack up my tools and tell him or her to call me when they have a definitive layout.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Measuring for laminate flooring [ 1 Answers ]

Hi I was wondering if anyone could help me out I was looking at this laminate floor and on the box it says its covers 20.02 square ft per case. When I measured my floor with a tape measure it said 20ft by10 ft rounding off to the higher number so I was wondering if anyone could help me to how many...

Bush positioning to be a dictator? [ 45 Answers ]

President Bush has signed a directive granting extraordinary powers to the office of the president in the event of a declared national emergency, apparently without congressional approval or oversight. The "National Security and Homeland Security Presidential Directive" was signed May 9, notes...

Measuring cups [ 9 Answers ]

I'm British living in Poland and am unable to get the 'measuring cups' used in american recipes. Can anyone tell me roughly the size of cup used. Is it a traditional tea cup size? My scales convert from oz to grams, is there any easy way to convert for example 1 cup of sugar or flour into oz or...

Sink drain positioning [ 1 Answers ]

I Am Remoldeling Kitchen. Drain For Sink Coming Out Of Floor Is 11" On Center From Wall. The New Wall Will Be 3" Closer To Drain(8" From Wall On Center). Do I Have To Move The Drain To Be Able To Hook Up The Sink?


View more questions Search