 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
My furnace pilot would not stay lite, changed the thermcouple but pilot would still not stay lite, i installed a new gas valve, now pilot will stay lite until the unit lites up the furnace unit will come on and pilot goes out and unit stays on for about 3 min and then i hear a click and the furnace...
I have a heatmaster furnace by westbrook distributing. I need to lite the pilot to get the heat working. The model # is HAC075NS3R. The serial # is 860626216. The PT # 1343122850. 75K BTU. Please advise. Thank You, David Green
Trane TUE060A936HI Ser K 412MYH@G The gas is on; the thermostat is on, the fan for the furnace kicks on when I turn the thermostat up. But the auto pilot light will not turn on. I don't smell any gas? Any suggestions
Hello, I purchased a Bryant gas furnace about 10 yrs ago. When I woke up this morning it was blowing cold air. My brother went down and looked at it and there was a red "led" light flashing on/off when he tried to get it to start back up. It was liting but now it isn't. Please help! :confused:
Hello, I have a Bryant furnace. It Keeps flashing code 13 on the circuit board. I read the code and it says that the switch will reset after 3 hours. It also refers me to # 33 which gives more possibilities as to what the problem may be. However it does say to reset the limit or flame roll out...
View more questions Search
|
