Ask Experts Questions for FREE Help !
Ask
    Halfabe's Avatar
    Halfabe Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Jan 22, 2008, 07:35 AM
    Bryant furnace blowing cold air and pilot won't lite
    Hello, I purchased a Bryant gas furnace about 10 yrs ago. When I woke up this morning it was blowing cold air. My brother went down and looked at it and there was a red "led" light flashing on/off when he tried to get it to start back up. It was liting but now it isn't. Please help! :confused:
    Halfabe's Avatar
    Halfabe Posts: 3, Reputation: 1
    New Member
    		  
    #2

    Jan 22, 2008, 08:12 AM
    My brother reset it and did a couple of things and it is working. He is not exactly sure what he did but it worked, thank goodness! Thanks to all that viewed my post. Amy
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Why does my furnace blows out cold air when it should be blowing out hot air? [ 7 Answers ]

Why does my furnace blows out cold air, when it should be blowing hot air?

Bryant furnace does not come on [ 3 Answers ]

We have central AC/Heating with separate Bryant heating and AC units that are controlled from the same thermostat in the house. When I turn the Heat ON and set Temp to way higher than current Temp, the light on the thermostat comes on but the heating unit does not go on... no sound of burners...

Gas furnace blowing cold air (Bryant 310AAV) [ 5 Answers ]

Folks, Could really use some help/advice. I have a Bryant 310AAV gas furnace installed in our home. This is new construction (4 years old) so I assume it's one of the new furnaces that does NOT have a pilot. Here is the problem: The furnace is not blowing any hot air. I've turned the...

Bryant furnace won't lite [ 3 Answers ]

Hello, I have a Bryant furnace. It Keeps flashing code 13 on the circuit board. I read the code and it says that the switch will reset after 3 hours. It also refers me to # 33 which gives more possibilities as to what the problem may be. However it does say to reset the limit or flame roll out...

Bryant furnace starts then stops [ 3 Answers ]

My Bryant forced hot air furnace gets the signal to ignite, the pilot light and then the furnace lights but it goes out in a few seconds. This will happen over and over and then occasionally it might stay lit and warm the house. Any ideas of what this could be and how to fix it. Much...

View more questions Search