T-stat

Check out some similar questions!

Wiring a honeywell L641b 1004 pipe stat with a normal air monitored frost stat [ 0 Answers ]

I have a garage located boiler with a typical frost stat above it .I have a honeywell L641b 1004 pipe stat that I wish to monitor the return to boiler . If possible I would like to wire it so that the system fires up on hot water and not heating , I hope this makes sense.. I have a y plan..

2-wire hook-up from a Carrier stat to a 3M30 Filtrete stat? [ 0 Answers ]

Ok what I have is a Carrier {edge}. Removing it to install a Filtrete 3M30. I have two wires coming from the wall. One white & one red. The back plate to the Carrier has a 4-wire hook-up. From the wall wires red go's to V White go's to Vg Then there are two wires coming from the back of the...

Lennox 51M33 stat to Hunter 44860 stat [ 4 Answers ]

Lennox Heat Pump with Electric heat backup Lennox 51M33 wiring O - orange R - red G - green Y1 - yellow W1 / E jumper - white L - light red (pink) C - black T (Outdoor temp sensor) - blue

Replacing honeywell stat to an other honeywell stat [ 19 Answers ]

I'm switching my old stat to a new one that lets me enter a program. I have an electric central air furnace and a thermopump outside that provides heat and AC. I'm going from a honeywell CT3600 or so (looks the same as in the manual for that one but without the program buttons) to a RTH8500....

Just 3 wire T-Stat connection, new stat, diff letters [ 6 Answers ]

Hi all, I've done tons of reading and can't find my specific wiring, tstat combo to figure it out... hopefully someone can shed some light on it for me. Natural gas forced air furnace, no air conditioning. Had a honeywell for the last 9 years, easy install, labelled easy. (but its dead) Wire...

View more questions Search

Check out some similar questions!

Add your answer here.