Ask Experts Questions for FREE Help !
Ask
    paulmceneany's Avatar
    paulmceneany Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 21, 2007, 08:20 PM
    Electrical wiring
    In a legal settlement I agreed to allow my neighbor to install a driveway gate controller on my property.

    My neighbors have more money than they can spend and enjoy taking control of my property and harassing me and my wife.

    When they installed the controller they had the gardener dig a 9" deep trench and install what iI believe is irrigation plastic pipe'

    Then an installer ran multiple wires unlike the 12 gage low voltage wire I used for my outdoor lighting

    Is this 110 voltage and did they install it deep enough
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
     
    #2

    Mar 22, 2007, 03:18 AM
    First ask the town if a permit was taken out for this electrical work.

    The voltage may be low voltage or may be 120 volts, if low voltage not more than 30 volts ,this is OK, if 120 volts it needs to be no more than one 20 amp circuit,GFI protected and at least 12 inches deep.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Electrical wiring [ 3 Answers ]

Please help! How do I connect a pull chain switch to a regular light fixture?:confused:

Electrical Wiring [ 1 Answers ]

I have a 2 story house with 2 electrical panels. The house was built in the 60s. I want to move the panel in the living room to the panel in the basement, an install with 200 amp service. How do I go about removing the panel in the living room to the one in the basement without doing a total...

Electrical Wiring [ 2 Answers ]

Hello, I am wiring my basement. I am by no means a professional but I generally figure things out and like to adhere to code and inspections. I am running a line of recepticals around a corner. My questing is, Do I have to drill holes in the 2X4's in the corner or can I bring the cable up...

Electrical wiring [ 1 Answers ]

How to wire a sub panel for the purpose of installing a new elctric range in a remodeled kitchen. The main panel is a 100 amp square d breaker box , as is the new sub panel box. Sincerely, bill rinaldi Scranton, pa.

Electrical Wiring [ 2 Answers ]

I currently have a 20 amp circuit for my frig outlet in the basement. I would like to install a recessed 6" IC Halo fixture on this circuit. To do so, can I use a 14/2 gauge wire or should I use a 12/2 wire which is meant for the 20 amp circuit?


View more questions Search