Ask Experts Questions for FREE Help !
Ask
    Daryl298's Avatar
    Daryl298 Posts: 4, Reputation: 1
    New Member
    		  
    #1

    Nov 28, 2006, 11:14 AM
    Electrical Wiring
    Hello, I am wiring my basement. I am by no means a professional but I generally figure things out and like to adhere to code and inspections. I am running a line of recepticals around a corner. My questing is,

    Do I have to drill holes in the 2X4's in the corner or can I bring the cable up the stud on one side of the corner and go through the rafters then back down the other side of the corner?
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
    		  
    #2

    Nov 28, 2006, 12:36 PM
    Either way is fine. An electrician would probably try to drill through the corner studs, they usually have very long drill bits, and can drill two holes into the opposing studs, and have the two holes meet. But going up, over and down is fine.

    Keep any homes drill, and cables stapled, at least 1-1/4" away from the front face of a stud or joist, to keep the cable clear of sheetrock screws and nails.
    Daryl298's Avatar
    Daryl298 Posts: 4, Reputation: 1
    New Member
    		  
    #3

    Nov 28, 2006, 04:39 PM
    Hey thanks a lot. Just found this board today, I know I will be back!
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Thermostat and electrical baseboard wiring [ 3 Answers ]

Hi, I just installed 2 thermostat and 2 baseboards but none are heating... I wonder if my wiring is OK. I have 120 on both wires in the baseboard but no heat at all... here is a diagram of my wiring. The wiring in my baseboard is OK. On one side, I have 2 wires linked with a wirenut and on the...

Electrical wiring [ 1 Answers ]

How to wire a sub panel for the purpose of installing a new elctric range in a remodeled kitchen. The main panel is a 100 amp square d breaker box , as is the new sub panel box. Sincerely, bill rinaldi Scranton, pa.

Hot Tub Electrical Wiring [ 1 Answers ]

I am getting ready to install a Dimension One spa that the manufacture calls for using #6-3 awg wire and 240 Volt - 50 Amp with a GFCI breaker and disconnect. I had the house pre wired for a hot tub and 240 Volt service. They installed a 50 Amp breaker in the main box and ran about 40...

Electrical Wiring [ 2 Answers ]

I currently have a 20 amp circuit for my frig outlet in the basement. I would like to install a recessed 6" IC Halo fixture on this circuit. To do so, can I use a 14/2 gauge wire or should I use a 12/2 wire which is meant for the 20 amp circuit?

View more questions Search