 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Goodman GMPN060-3 furnace burners go off after a few seconds
I have a Goodman GMPN060-3 gas furnace. My ignitor will glow and ignite the burner but will go out in just a few seconds. I have replaced the ignitor, pressure switch, and flame sensor but still have the same problem.The furnace will try to ignite three times before shutting down. Sometimes it will ignite and continue burning on the second or third try. Sometimes it will burn on the first try. There is nothing consistent about this problem. The bad part is waking up in the morning to a cold house. Any suggestions on how to solve this problem?
|
||||
Check out some similar questions!
Hi I have a White Rodgers furnace for the past couple years it would work fine that every once in awhile the burners would stop firing after 3 to 4 seconds and I would give have a good smack with a hammer screwdriver right near Word says pilot shortly afterwards would start running fine and stay on...
I have a Goodman Furnace Model GMPN060-3. I get three blinks biagnostic code. I changed venter (motor assembly) and pressure switch. Still the same three blinks. Moisture drain path is clean and free of debries. After the new parts, furnace started once, but would not start again -- same three...
Inducer motor runs, flame lights for a few seconds, goes off. Tries 3 times then turns off. Signals with 1 blink. So far, flame sensor has been cleaned, safety switches tested, Inducer motor safety switch has been jumpered out. Nothing changes.
How do I ignite the burners on a goodman furnace?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
