 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
White rodgers rpj 2 furnace burners run only for 3-4 seconds
Hi I have a White Rodgers furnace for the past couple years it would work fine that every once in awhile the burners would stop firing after 3 to 4 seconds and I would give have a good smack with a hammer screwdriver right near Word says pilot shortly afterwards would start running fine and stay on recently but I need giving it a good whack isn't cutting it anymore what is going on with this thing is it going to be something worth saving or my going to need a whole new furnace please help, what part of my looking for that usually goes wrong and what's the cost of fixing it even a rough estimate would be a big help
|
||||
Check out some similar questions!
I Have a White-Rodgers 1f80-44 Thermostat, when increasing the temp. above the physical house temp. example the house temp is at 66 I increase the temp manually to 71, I do not hear the typical click that happens to activate the thermostat?? Therefore is my Thermostat not functioning?
Blinks 8 times and my manual only goes up to 7 blinks
My Problem: My furnace is pumping out tepid cool air Last night my house started blowing tepid cold air. I turned the heat down until it "clicked" off from the thermostat in the main room. I went down into my basement and opened up my furnace. I had not changed the filter in the last 3 years...
I woke up this morning full of Christmas cheer and then I noticed it was too cold (I have compromised with my wife to turn the heat down to 65 degrees at night, but not 60! Brrr!) I noticed the circuit breaker was tripped so I reset that. The circulation blower comes on but no ignition or...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
