 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Goodman furnace gmpn060 flashing codes
Inducer motor runs, flame lights for a few seconds, goes off. Tries 3 times then turns off. Signals with 1 blink.
So far, flame sensor has been cleaned, safety switches tested, Inducer motor safety switch has been jumpered out. Nothing changes. |
||||
Check out some similar questions!
I have a Goodman Furnace Model GMPN060-3. I get three blinks biagnostic code. I changed venter (motor assembly) and pressure switch. Still the same three blinks. Moisture drain path is clean and free of debries. After the new parts, furnace started once, but would not start again -- same three...
Hello ! I am an auto mechanic, so when it comes to furnaces, I know nothing, but I have been learning about my furnce today. I have a goodman GMP-150-5 furnace that when the thermostat turns it on, I haer the draft fan start and run and after about 5 minutes, it just shuts down. Now, I looked at...
Hi, I have an older model goodman furnace that powers up the vent fan and proceeds far enough in the sequence for the electric igniter to glow, but then never releases gas to complete ignition. I replaced the gas valve last year, so I am hoping it isn't this again. I am getting an error code on the...
Eleven year old Goodman gas furnace. The main vent blower will start, but that's where things end. The draft inducer motor doesn't start and nothing else in the chain obviously happens after that. The LED on the board stays red and never flashes any codes. I checked the voltage coming into...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
