Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Has anyone ever seen this type of tub faucet valve?
[ 1 Answers ]
I can't figure out what brand this is and I don't have the paperwork from the remodel. The top lever switches tub to bath, the middle is the temp regulator, and the bottom is the drain plug. cj4rbw6161acs
Has anyone ever seen this type of tub faucet valve?
[ 1 Answers ]
I can't seem to find the brand of this temperature regulator. It's seal went bad and I need to find where to order the replacement from... The trim plate has temps from 55-115. The top valve switches tub to bath and the bottom one plugs the drain.. cj4rbw61acs
Single valve tub faucet problems.
[ 1 Answers ]
My single handle valve in my bath stopped working. If I have it set on cold all is well, but when I turn it to add hot water to the mix the handle is pushed forward and all water flow ceases.If I apply pressure to the handles the water flows. If I turn the valve to a cold only position, the valve...
Cannot redirect water from tub to shower in Bathroom tub water fixrure
[ 1 Answers ]
I have a Mohen bathtub fixture. When pulling the stem on the spout to change from bathtub to shower, water does redirect to the shower head but continues to flow from the tubspout. I have removed the spout and the shower head and the water flows properly (from both) Could someone please advise...
Distance between water cutoff valve and washer
[ 4 Answers ]
Hi, I want to install my washing machine water valve on the side of my washing machine so I can stack the washer and dryer and still have access to the valve. The installation instructions that come with the valve ( standard Watts 1/2" dual ball valve) say that the valve should be 3" above the... View more questions Search
|