Ask Experts Questions for FREE Help !
Ask
    jrmtx's Avatar
    jrmtx Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 19, 2011, 03:24 PM
    1996 GMC starting problem
    Sometimes, when I try to start my 1996 GMC it will click once but won't start. Truck can sit for a while and might start. Problem is erratic. Could this be the starter solenoid? When truck does start it runs great. Battery is good.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Feb 19, 2011, 04:12 PM

    . Remove and fully charge the battery. Most auto parts stores will do this for free.

    . Replace the starter solenoid, or complete starter motor, if the problem persists.
    CaptainRich's Avatar
    CaptainRich Posts: 4,492, Reputation: 537
    Cars & Trucks Expert
    		  
    #3

    Feb 20, 2011, 06:41 AM

    Visibly and physically inspect both ends of both battery cables. Make certain they are clean and tight.
    The Positive cable on these batteries are the most likely to have issues: corrosion here can cause many problems.
    On some configurations, there are actually two cable ends and a lead spacer on the Positive connection.
    With the cable(s) disconnected, inspect inside the Red protective end by probing with a stout pick or small screwdriver. The cable's surface should be shiny and clean.
    If the cable eyelet is badly corroded, you may need to replace that cable.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1996 GMC / Chevy S10 Blazer Steering Wheel Removal [ 2 Answers ]

I need to remove the steering wheel on a 1996 GMC S10 Blazer with tilt. I am already familiar with disabling and removing the air bag, and removing the nut that holds the steering wheel to the column. Chevy has a special puller to remove the wheel. My question is, can I use a generic puller...

1996 GMC Jimmy-high pitched noise [ 3 Answers ]

I have a 1996 GMC Jimmy. When the vehicle is moving I can hear a high pitched noise emanating from the front of the vehicle (it sounds like it is coming from the both the drivers and passengers side wheel areas), however, it immediately stops when I press the brake. What is causing this noise?

1996 GMC PU w/V6 and manual trans (wont start) [ 2 Answers ]

Intermittant "won't start" problems. I have replaced the crankshaft sensor, camshaft sensor, fuel pump (twice), plugs and plug wires and fuel filter. There are no codes when I scan the computer and the truck runs fine when it does start. The truck has 179,000 miles on it and is in great...

1996 GMC Pick up V6 Engine [ 1 Answers ]

On the compression stroke, are the intake and the exhaust valve closed at top dead center?

More Help Needed On 1996 Gmc Pickup, V6 With Vortek Engine [ 1 Answers ]

The distributor is removed, timing chain and sprockets removed, and the motor has been turned over. I'm now ready to align everything to include how I align the balancer shaft sprocket with the cam shaft sprocket. Upon lining that up, I install my timing chain and cam gear - I need instructions...

View more questions Search