Ask Experts Questions for FREE Help !
Ask
    jchoo's Avatar
    jchoo Posts: 69, Reputation: 2
    Junior Member
    		  
    #1

    Feb 5, 2011, 07:54 AM
    Uneven closet flange
    I'm about to install a toilet in my basement and the closet flange is uneven. The floor is concrete. One side of the flange is above grade and the otherside sits approx 1/4" below. How can I solve this so that my toilet does not leak?
    joypulv's Avatar
    joypulv Posts: 21,591, Reputation: 2941
    current pert
    		  
    #2

    Feb 5, 2011, 08:04 AM
    They sell closet flange extenders, and the kit may come with plastic shims for leveling, or you can buy them in the tile department.
    jchoo's Avatar
    jchoo Posts: 69, Reputation: 2
    Junior Member
    		  
    #3

    Feb 5, 2011, 08:09 AM

    Thanks joypulv. Can 2 wax rings work to?
    joypulv's Avatar
    joypulv Posts: 21,591, Reputation: 2941
    current pert
    		  
    #4

    Feb 5, 2011, 08:18 AM
    Yes, but some people claim that makes the toilet sort of move around when you sit on it..
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #5

    Feb 5, 2011, 08:57 AM

    Hi all...

    I'd purchase an EXTRA THICK reinforced wax gasket and extra long closet bolts for this job... should be all you need!

    Mark
    ChazC's Avatar
    ChazC Posts: 5, Reputation: 1
    New Member
    		  
    #6

    Feb 5, 2011, 10:34 PM
    If you think it's that bad,double up on wax gaskets,but DO NOT use the ones with the plastic horn encased in the wax,you want strictly the wax ring type! This will guarantee a good seal,
    jchoo's Avatar
    jchoo Posts: 69, Reputation: 2
    Junior Member
    		  
    #7

    Feb 5, 2011, 11:47 PM

    Thanks to all. I used a closet extension kit and it is a success.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Uneven closet flange [ 1 Answers ]

I'm about to install a toilet in my basement and the closet flange is uneven. The floor is concrete. One side of the flange is above grade and the otherside sits approx 1/4" below. How can I solve this so that my toilet does not leak?

Uneven floor around closet toilet flange [ 2 Answers ]

I am replacing the seal on my toilet and the subfloor is uneven around the closet flange. The toilet was originally placed on a seam in the subflooring--very small bathroom only place that the toilet would fit-I guess. What do I do know? Rubber shims? Is that going to work. I am replacing the...

Installing closet flange where old flange top non existent [ 3 Answers ]

I am flooring in the basement bathroom and need to be able to set the toilet at a higher level. The flange part of the flange has been removed - there is now a pipe with the tubular part of the flange glued into it. How do I install a new flange with the appropriate extensions?

Hole in floor is larger than closet flange, and the flange may be too low [ 3 Answers ]

We recently put down ceramic tile in one of our bathrooms. A friend of ours did the job for almost nothing, as he had most of the required supplies left over from another job, including tile. Now there is water leaking from the base of the toilet. After scouring the DIY sites on the internet, I...

Closet flange on uneven slab [ 3 Answers ]

The cement within a ring of about 3 or 4 inches around the soil pipe is uneven. There is a slight grade up toward the pipe. The grade is about quarter to a half inch. Do I need to grind this down a little or do I try to float some leveling cement around the pipe to get a better area to put the...

View more questions Search