 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Draft inducer or control module
I have a consolidated industries hot air heating system and I am having a problem with the draft inducer going on and off by itself even if I shut off the thermostat. I can hear the control module clicking on and off when the motor goes on and off and was wondering if it could be a bad control module or is the thermostat bad? How do I check these items?
|
||||
Check out some similar questions!
I have a 5 yr. old dunkirk xeb3 boiler. This year on starting I noticed a smell of burnt gas coming out from around the draft inducer housing. I checked housing and gasket, both seemed fine. Fan only runs for approx. 5 seconds before ignition, and shuts off right after flame stops. Could this be...
...
FURNACE: Made by: Goodman Model #: GMPN080-4 THE POWER VENTER (this is what the Goodman manual calls it but other websites refer to this as the Heat or Draft Inducer): Made by: FASCO Industries 70219565 Type: U218 Volts: 115 RPM3400 Customer Part #: B2833001S
The draft inducer on my furnice is stuck or something, it makes a humming noise for an extended period before the heat kicks on. The blower, the heat ignition everything is fine. It also seems like it starts too frequently.
I have a Janitrol Furnace that will not start up. I pulled of the tube from the draft inducer to the pressure switch. I sucked on the tube and the furnace fired up. So I checked the voltage going to the draft inducer, it read only 6v ac. Where do I go from here?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
