Ask Experts Questions for FREE Help !
Ask
    gbelectric's Avatar
    gbelectric Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 15, 2010, 02:14 PM
    Luxaire furnace troubleshooting
    My furnace manual says I can set the fan off delay on the PC board.my model has no such jumper that I can see.does the primary limit switch (open@140/close@100)control the blower? After gas shutoff the blower runs twice as long as I would like, sending cold air into the rooms.
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
     
    #2

    Mar 15, 2010, 02:20 PM

    If there is no set pin on your control board, then it can not be changed. Do you have a white: white rodgers board?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #3

    Mar 15, 2010, 03:47 PM
    Exact model number of furnace?

    Exact model number and brand of circuit board?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Luxaire furnace troubleshooting [ 1 Answers ]

Luxaire propane furnace.. 4yrs old. Following a power outage... the furnace pre blower comes on fan comes on but no heat. Furnace is flashing 3 flashes . Filter is clean and blower motor seems to work on fan. Any thoughts.. Thanks Greg

Luxaire furnace troubleshooting [ 0 Answers ]

As far as I can tell I have an ignitor problem. Works intermittantly. Filter is clean, pre-blower activates appropriately and IF ingnitor comes on, then the gas ignites and all is well. Thoughts?

Luxaire furnace troubleshooting [ 1 Answers ]

I have a 2334 sg. Foot log home it has 2 3.50 ton units 1 of the units runs twice as much as the other.these are brand new units been in house less than year.Had the heat and air company back out to my house 4 times can't really tell me why they have closed down some vents at units didn't really...

Luxaire troubleshooting [ 0 Answers ]

Our luxaire is a high efficiency model and frequently will shot off before the requested temperature is reached. We just had the "Initiator Motor" (power vent motor) replaced because it seized up. I thought the issue was related but it is not. The problem happens several times/day. If I shut...

Luxaire troubleshooting [ 2 Answers ]

My LuxAire furnace runs intermitently but sometimes just cuts off and doesn't start again, then if I cut off the power and reconnect it the furnace starts for awhile. I am getting a code of seven blinks. It seems to run for awhile but nothing is consisitant? Please!


View more questions Search