Ask Experts Questions for FREE Help !
Ask
    RaybonSanderson's Avatar
    RaybonSanderson Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 26, 2008, 07:31 PM
    Blower stays on
    I have an old Bryant heater and the burners won't stay on until the thermostat setting is reached. The blower stays on but the burners will cycle on and off in short intervals.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #2

    Dec 26, 2008, 09:02 PM

    If it has one,, clean the flame senser
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #3

    Dec 27, 2008, 12:25 AM
    Quote Originally Posted by RaybonSanderson View Post
    I have an old Bryant heater and the burners wont stay on until the thermostat setting is reached. The blower stays on but the burners will cycle on and off in short intervals.

    It could be the three wire pilot safety. The can cause that problem.
    Attached Images
     

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Rheem Furnace Blower Stays On [ 2 Answers ]

I have a Rheem Criterion II (Model RGPH 07NAMGR) with the main furnace blower that runs continuously. The IFC board (62-24084-82) is giving me the three blink error (middle green light between a green and orange bulb) which I believe indicates an open limit switch. I have check the three limits...

Blower stays on [ 4 Answers ]

My blower fan on the inside unit stays on after thermostat cuts off.. I have a lenox model CB30M-312P.. INSTALLED 11/2004

Furnace Blower stays on too long. [ 1 Answers ]

Hello. I have a Honeywell Electric furnace. Model # AR36-1 The blower stays on too long after furnace shuts off and cold air blows out. Any ideas how to fix it? Thanks.

Blower stays on [ 1 Answers ]

I am working on a Tempstar furnace, Furnace blower comes on even thermostat is fully disconected from control board. Replaced control board and limit switch. Furnace still coming on. Checked all the wire locations. Tempstar model is - NFCX3600C1 Serial is- L001362305 Any...

Blower Fan stays on when it should not [ 2 Answers ]

New Amana heat pump system: outdoor unit ASZ140481A, indoor unit (in attic) AEPF426016B + TXV. Thermostat: TotalTouch P286-200. When fan setting is FAN AUTO and the system is not cooling or heating, the fan can come on and stay on for hours, or the fan stays on after heating/cooling stops. The...


View more questions Search