Ask Experts Questions for FREE Help !
Ask
    freemanfamily's Avatar
    freemanfamily Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 1, 2008, 06:15 PM
    Updating a to a RTH7000
    I have an old Honeywell thermostat (HH93AZ050) and want to install a new Honeywell RTH7000. My setup has a one unit under the house, and 2 zones (one for upstairs and one for downstairs) I am changing the upstairs to the rth 7000. The question is, the manual was not very clear, on this. The wires connected to the original thermostat was the red yellow white. There was several colors that was not connected, they wwas just tied back, and they were black, blue , brown ,orange , green and pink (which I state again for clarity, was tied back not connected)
    From the manual we followed the setup for the "conventional heating and cooling" (page 9 from the manual ) this hooking up the red, yellow white ,green. Does this sound right, everything seems to be working, but the thermostat does not seem to be cooling to the setting we programmed in...
    Thanks for any response...
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jun 1, 2008, 08:32 PM
    If it is working it must be OK. Did you putty the hole where the wires come out of the wall? In the set up feature did you pick out F or C for the temp read out if that selection was available?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trane Weathertron to Honeywell RTH7000 Wiring instructions. [ 3 Answers ]

I need wiring instructions. I have a Trane Weathertron thermostat and I want to replace with a Honeywell RTH7000. The Trane Weathertron terminals are as follows: B= Blue X2=Black W= White T= Brown G= Green O= Orange Y= Yellow R= Red

Wiring RTH7000 Thermostat [ 1 Answers ]

I am converting from an old Honeywell (Chromotherm III) to a new RTH7000 and the contractor who disconnected the old one didn't write down which wire went to which connection... So I'm stuck with five wires as follows: One wiring group (all coming from one common tube) consisting of RED, WHITE,...

Installing Honeywell RTH7000; where does the X1 go? [ 7 Answers ]

Ok here are all the details. I started with a White-Rodgers Thermostat Type 1F58W-72 and bought a Hunter Set & Save Programmable Thermostat Model 44155C. I took the old one off and labeled all the wires for the new one according to the instruction. It all went well until I realized I had one...

Rth7000 fan or blower does not turn on.. Help! [ 3 Answers ]

Hello, I just bought rth7000 programmable thermostat to replace the original thermostat. Unfortunately, after installing the new rth7000, it powers up and I can access the setting on the thermostat and I also hear it clicking when I try to turn on either heater or ac but nothing blows out, no...

Honeywell Rth7000 Thermostat [ 5 Answers ]

I just bought a honeywell rth7000 thermostat, i am installing in a old house that only uses 2 wires, one is green and the other brown, can anyone advise me how to connect these 2 wires to this unit i am not sure exactly where to connect them to on the honeywell thermostat--thanks

View more questions Search