 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Plenty of hot but no cold.
It's been going on for a while but I seem to have plenty of hot water but very very little cold water. I turn the cold water on and it's just a little trickle but when I turn on the hot water, it goes full force. It's this way for the kitchen and both my bathrooms. The toilet also doesn't fill up and it's no cold water for my washer, dryer, or dishwasher either. I haven't tried anything because I don't know too much about plumbing and didn't want to screw it up more. The one thing I have done is check for freezing pipes and it's not that. If someone could please help, I would greatly appreciate it. I'll provide any information needed.
|
||||
|
||||
|
Since cold water feeds your hot water heating source and you have good hot water pressure you will find the problem to be AFTER the cold water main feeds the hot water heater. My guess is that you have a shut off after the water heater feed and that is clogged (if present, close and then reopen and see if that helped at all).
Post back... Mark |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Hi, I own a small plumbing service and have a problem I've never encountered before. I installed a new top vented gas water heater for a customer. Turned the main back on, bled air out of the lines, etc. Problem is there is no hot water pressure throughout the house. Cold water pressure is fine....
Throughout the house each faucet gushes out with hot water and the cold is only a slow stream. Mixing using the handles yields less warm water pressure than hot alone. What do you suggest water from main is fine.
Our guest Moen tub/shower is not used very often. (The house is 3 years old.) We were cleaning the tub and when we turned on the water we are only getting a dribble for hot water. When we switch it over to cold it comes on full force. There are no issues with hot water elsewhere in the house. ...
I have very little hot water in the bathroom sink or the shower. However in the kitchen and mater bath the water is fine. What could be the cause of this and how can I fix it? :confused:I am female and widowed so must learn to fix these things myself if I can. SO please bear with me and you will...
When I turn on my hot water on any faucet in my house I get about 2 seconds of water then nothing. I have plenty of cold water and pressure. I've turned the breaker off at the hot water pump and back on. I've shut the hot water valve off numerous times and get the same issue. I've waited 30-45...
View more questions Search
|
