 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Infrequently used guest shower has only a dribble of hot water and plenty of cold??
Our guest Moen tub/shower is not used very often. (The house is 3 years old.) We were cleaning the tub and when we turned on the water we are only getting a dribble for hot water. When we switch it over to cold it comes on full force. There are no issues with hot water elsewhere in the house. This happens both when the plunger is up for the shower and down for the tub.
Hopefully someone has a quick fix as we have 6 houseguests coming tomorrow! |
||||
|
||||
|
It sounds like you have problem with your cartridge, shut the water to the house, remove the handle and the cartridge, with the cartridge removed ask some to turn on the water for a few seconds to flush out any debris out from the faucet, now check the cartridge for O rings on cartridge for any damage if it is damaged you will need to replace the cartridge, if no damage clean, lubricate and install, check if it works. If it would not work you will need a cartridge, and you can get one from Moen for free no charge to you call Moen support at 800-289-6636, good luck. John |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Hi, I own a small plumbing service and have a problem I've never encountered before. I installed a new top vented gas water heater for a customer. Turned the main back on, bled air out of the lines, etc. Problem is there is no hot water pressure throughout the house. Cold water pressure is fine....
I have very little hot water in the bathroom sink or the shower. However in the kitchen and mater bath the water is fine. What could be the cause of this and how can I fix it? :confused:I am female and widowed so must learn to fix these things myself if I can. SO please bear with me and you will...
The shower in my ensuite is the highest flowing water in the house. Its on the regular hot water system (ie not a powered electric shower) It has a Mira control for hot and cold water. Hot water pressure in the shower has always been "weak" and hot water was always slow to start flowing. ...
When I turn on my hot water on any faucet in my house I get about 2 seconds of water then nothing. I have plenty of cold water and pressure. I've turned the breaker off at the hot water pump and back on. I've shut the hot water valve off numerous times and get the same issue. I've waited 30-45...
View more questions Search
|
