Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Furnace gas valve not opening
[ 2 Answers ]
Regarding my Bryant/Payne 383KAV gas furnace: At startup both fans cycle as expected and the HSI gets red hot, but the gas valve does not open... no flame. It continues this cycle over and over. I have been unable to find any reset switches and have tried tapping on the gas valve solenoids. Any...
Gravity furnace gas valve
[ 3 Answers ]
Have an old gravity furnace. Pilot generator putting out 575 mv, however gas valve won't open (ITT General Controls B60 gas valve). How do I troubleshoot valve? What external or internal checks? I have the valve head off and looking under the diaphragm I don't see anything obvious. I'm not...
Carrier Natural Gas Furnace main gas valve will not open every call for heat
[ 1 Answers ]
We have a Carrier Weather Maker 8000 Natural Gas Furnace not functioning properly. We have replaced pressure switch, hot surface ignitor, flame sensor and control board. It will cycle 3 to 4 times and then not come back on. Is it possibly a bad coil on gas valve?:rolleyes:
Furnace goes on then gas valve shuts off
[ 1 Answers ]
Goodman 115-5 forced air furnace the furnace kicks on the glo-plug lights flame and then immediately goes out
Gas furnace valve
[ 1 Answers ]
I read one of the Q & A's about a gas valve for an Empire direct vent wall furnace, model #DV-215-7SG-LPG. So far I've been able to determine that it's the solenoid that's bad, anyhow,I've replaced it with a new valve and I've been serarching desperately to find another replacement valve for 2... View more questions Search
|