Ask Experts Questions for FREE Help !
Ask
    bsimen's Avatar
    bsimen Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 7, 2008, 03:30 PM
    Gas furnace valve
    I read one of the Q & A's about a gas valve for an Empire direct vent wall furnace, model #DV-215-7SG-LPG. So far I've been able to determine that it's the solenoid that's bad, anyhow,I've replaced it with a new valve and I've been serarching desperately to find another replacement valve for 2 other wall furnaces that are exactly the same model. Hopefully something cheeper than $ 129.00.
    Can you help me?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Mar 7, 2008, 08:06 PM
    Check this. You might be able to get this person to strip the parts.

    EMPIRE PROPANE LP GAS WALL FURNACE HEATER 15,000 BTU - eBay (item 160216278039 end time Mar-10-08 18:53:10 PDT)
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Gravity furnace gas valve [ 3 Answers ]

Have an old gravity furnace. Pilot generator putting out 575 mv, however gas valve won't open (ITT General Controls B60 gas valve). How do I troubleshoot valve? What external or internal checks? I have the valve head off and looking under the diaphragm I don't see anything obvious. I'm not...

Furnace blower/ gas valve issue [ 1 Answers ]

Hello everyone! This morning before I hopped in the shower, I bumped the temp in the house up from 62 to 67. Well the furnace went through it's normal procedures and I noticed the blower turned off very quickly and I can hear the igniter trying to light the burners again. Well, not thinking...

Gas valve will not open on intertherm furnace blower is stuck [ 4 Answers ]

Intertherm furnace pilot is lit but burner will not I have 24 volts at valve

Replacement of a gas valve in a goodman furnace [ 1 Answers ]

I am replacing a valve in a 10 year old goodman furnace. The old valve has an orange lead in going to the "m" terminal and blue and green leads going to the "c" terminalfor a total of three leads . The new valve only has two terminals . How can I connect the new valve thomdunkneedshelp

View more questions Search