 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Circulating pump only turns on when I turn dial on thermestat for stove with back boi
I have a stove with back boiler my problem is my circulating pump only kicks in when I turn the dial on thermostat but it will remain on even when pipes are cooled until I turn the dial again. I've tried changing the connections in the stat but the same problem persists
|
||||
Check out some similar questions!
In heat mode after temp reached.HP and it's fan go off,but not house fan. COOL works OK. Have Robert shaw 4220. Removed "G" wire on stat block and fan still doesn't turn off.Thanks Dan...
Hi. I've been having a problem for a few days. I have a split-ac system only 2-3 years old. I usually leave the system on auto and cool. Lately, the compressor unit works for some time, then turns off but never comes back on again. However, the blower keeps running. I have replaced the furnace air...
The heat on the second floor of my home is blowing cold... its a 2 zone weil mclain hydro system... the st floor is hot... the second is cold what I have observed so far 1. the boiler control unit has a light blinking... limit 2. if I touch the pipe just below the circulating pump its very...
While waiting for my heater expert to come and take a look at the heater, I'm trying to figure out if the problem is with my heater or thermostat. I don't know the make/model of my heater as it is on the roof, but my thermostat is a Hunter #44110. The heater does several different things on any...
I recently purchased a pellet stove for my 24x24' attached garage which is now my electrical shop. The door from the garage enters into my kitchen, I have a 1,200 sq' 1 story L shaped ranch house with forced hot air heat. At the far end of the house is the living room, an office and the master...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
