 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Levitron motion sensor light switch pr 180 won't go on
The light sensor turns the light on the first time you walk by and turns the light off as set (about one minute). But then won't turn the light back on again unless I turn it to off and then back to auto.
This is a three pole sensor. The switch at the bottom of the stairs is a standard on/off and the Levitron Sensor is at the top of the stairs. I wired black to black, red to red, and the yellow wire from the sensor to the white wire out of the wall. The ground is against the box, but not screwed in (couldn't get to it). Any thoughts. I can be contacted at e-mail [email protected] Thank you. Lyle Duer |
||||
Check out some similar questions!
I tapped into some older threads on this question, so I thought it best to ask again because the documentation for the PR 180 seemed to have some ambiguities. I have a stair case with one light at the landing controlled by two switches, one at the bottom of staircase and the other at the top. I...
I am trying to replace a single pole electrical light switch with a single pole motion sensing light switch. The problem I'm running into is after replacement of the wiring and placing the new motion sensor in the electrical box, the sensor is too far recessed into the electrical box. As a result,...
I have installed 2 or 3 motion sensor light switches in two different locations in my house and all have failed after a while. They continue to work as regular switches, but the motion-sensitive feature stops working. Could there be any problems with the house wiring that causes this?
The switch as four wires: one black, one brown, one red, and one green. I know what to do with the black and green wires. My problem is what to do with the brown and red wires. Does one or both of them connect to the white wire?
I have power coming in from the basement to the first floor 3 way switch with a 4 way switch on the second floor and a 3 way on the top floor. The 3 way on the third floor appears to go to the lights. The 4 way has two wires going down as travelers to the first floor and two wires as teavelers to...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
