 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Munchkin boiler leak
I have a munchkin boiler with two of the sensors on the top left of the unit (cover removed) that have been leaking. I think one is a thermistor and the other is a flow sensor. Is it OK to use a wrench to tighten them to stop the leak or should I replace them. The leak appears to be where they are threaded in but I'm not sure. Also there is an F02 error code which is a thermistor. Not sure which one,there are two thermistors. Also the boiler is not working now. I assume the error code is preventing it from working. Any help is greatly apprreciated.
Larry |
||||
Check out some similar questions!
Our back boiler heats the water via the open fire. Lately the water is slow to heat in the cylinder and the pipes leading into the tank are extremely hot but the cylinder eventually heats but totally to the bottom of the tank. Would the back boiler be leaking or just full of gunge from 19 years of...
Hi I have a ferroli Modena 80e boiler & underneath the pipe on the left (radiator pipe I think) is leaking where the tiny screw goes but the screw has lost it's thread so I can't tighten or loosen it? & this is making the pressure drop.
I have a Hobart 600 automatic gas fired furnace. The first thing is I cannot see a circulater pump or a air tank. I can not tell if it is steam or hot water. When I go to fill the system with water, the system fills and then the water continues to flow out to the drain pipe.
We have recently had a new boiler fitted by a gas safe engineer and we have noticed our extension roof has gone brown since this has been fitted and also the waste pipe from the bathroom looks like a leak causing the extension roof to to disfigure. Need help to try and figure this out before the...
Hi, and thanks for your time. I've a Utica boiler that I replaced the water glass tube a couple of years ago, and it's been working fine. Now the darned thing leaks from the bottom of the tube,:mad: requiring me to refill the tube a few times a week. :( I've tried loosening and relocating the tube...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
