Check out some similar questions!
How do I connect the 6 wires coming out to the ceiling to the 3 wires from the fan?
[ 3 Answers ]
I have two switches on two different walls. So there are six wires ( 2 black, 2 white, 2 bare) coming out of the ceiling. I purchased the Hunter Stratford II Model 20582 ceiling fan with light. How do I connect the six wires coming out to the ceiling to the three wires from the fan? Do I...
Ceiling fan 3way switch has 4 wires and new one has only 3 wires. How do I replace?
[ 1 Answers ]
The 3-way speed switch on my ceiling fan broke. I bought a new switch from Home Depot. The original switch has 4 wires, pink, yellow, grey and black. They are labeled black-L, yellow-1, pink-2, grey-3(strip). New switch has 3 wires, red, blue and black. Labeled, black-L, red-1, blue-2. How I...
Inside controls off.outside fan runs even when inside Heat is on
[ 2 Answers ]
My outside unit's fan still runs even when inside controls are all set to off, or even when inside heat is being used.
Filling holes from inside to outside where #8 or other romex wires go through
[ 3 Answers ]
I have air-conditioning #8 romex wire going from basement wall (wall is wood material) To the outside into a outside cutoff switch. I noticed air penetration is an issue with the One inch hole that the previous electrician drilled to the outside for this. I used caulking with little bit of...
Hampton Bay remote wires do not match fan wires
[ 1 Answers ]
Yesterday I installed a new Hunter ceiling fan. I also purchased a Hampton Bay wireless wall switch. Everything went well until I wired up the remote receiver. The receiver has a blue wire for the light that is supposed to connect to the blue wire (light) from the fan. The Hunter fan does not have... View more questions Search
Add your answer here.
|