Ask Experts Questions for FREE Help !
Ask
    duffy-lan's Avatar
    duffy-lan Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 7, 2013, 05:21 AM
    Goodman amana electric furnace
    I had my oil furnace replaced with and electric furnace connected to an existing
    Heat pump. I have found that the installers have used the existing circuit control board to control the furnace. Is it standard procedure to install new board when installing a new electric furnace to replace oil. Furnace is staged model 15 kw.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Jan 7, 2013, 06:41 AM
    ?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #3

    Jan 7, 2013, 10:04 AM
    i had my oil furnace replaced with and electric furnace connected to an existing
    heat pump. I have found that the installers have used the existing circuit control board to control the furnace. Is it standard procedure to install new board when installing a new electric furnace to replace oil. Furnace is staged model 15 kw.

    No SOP here to replace. Ok to use board. If it works it works!
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Amana 80 see furnace [ 0 Answers ]

I have an amana 80 see furnace and it comes on and lights for a second than shuts off does this several times then sometimes when it comes on it lights fine and stayes running until it reaches desired temp then shuts off like normal

New goodman heat pump with electric banks back up [ 0 Answers ]

When cold outside around ten degrees banks will turn on until thermastate is within one degree of satifided, then outside unit will turn on and stay on until thermastate dropps and tell banks to kick back in. This cycle will continue until temp outside warms up enough until the heat pump warms...

Amana/goodman furnace [ 1 Answers ]

I am working on a Amana Gas Furnace, it's a 2007, don't have exact numbers with me. When kicked on, the inducer motor fires up, runs smooth, no clicks, ignitor does nothing, which in turn the gas valve does nothing, fuse is good, I checked the 24v Transformer, it has 115 in top, 27v out bottom, I...

Auto/ on switch on Goodman/Amana Heating/cooling unit [ 2 Answers ]

I have a Goodman/Amana heating and cooloing unit (Model # PTC073B35AE) that is hooked up to a remote thermostat. What shoud the auto/on of the unit itself be placed at. It seems to be running too much and my elelctric usage is way higher than should be.

I have an Amana 80+ furnace. [ 1 Answers ]

When the temperature reaches the desired setting, the gas burners turn off as they should, however the fan continues to run and blows cold air. The temperature dips well below the thermostat setting, but the burners do not turn back on and the fan continues to run. I also notice a flashing red...

View more questions Search