Ask Experts Questions for FREE Help !
Ask
    QUALITY1CONST's Avatar
    QUALITY1CONST Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 18, 2010, 08:40 PM
    Amana/goodman furnace
    I am working on a Amana Gas Furnace, it's a 2007, don't have exact numbers with me. When kicked on, the inducer motor fires up, runs smooth, no clicks, ignitor does nothing, which in turn the gas valve does nothing, fuse is good, I checked the 24v Transformer, it has 115 in top, 27v out bottom, I am guessing the board went out, any ideas?
    bernie1951's Avatar
    bernie1951 Posts: 12, Reputation: 1
    New Member
    		  
    #2

    Feb 20, 2010, 04:08 PM

    Sounds like a pressure switch instead of the board
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Amana furnace [ 2 Answers ]

Hi Everyone, I am having so much trouble, trouble shooting my furnace, I have a Amana Furnace, I noticed that the Burner is not staying long enough for the heat to blow through the vent. This is my observation, once adjusted the temp desired in the thermostat, the burner on the furnace...

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

Auto/ on switch on Goodman/Amana Heating/cooling unit [ 2 Answers ]

I have a Goodman/Amana heating and cooloing unit (Model # PTC073B35AE) that is hooked up to a remote thermostat. What shoud the auto/on of the unit itself be placed at. It seems to be running too much and my elelctric usage is way higher than should be.

Amana furnace [ 2 Answers ]

I misplace the wiring diagram and installation manual for my Amana Furnace. Any chance someone, website may have a good source for that: Mod # GUCO70B40A, Serial # 9110104173, Mfg # P9114303F Suggestions for a fix would be appreciated also: Having problems starting. The igniter works fine...

I have an Amana 80+ furnace. [ 1 Answers ]

When the temperature reaches the desired setting, the gas burners turn off as they should, however the fan continues to run and blows cold air. The temperature dips well below the thermostat setting, but the burners do not turn back on and the fan continues to run. I also notice a flashing red...

View more questions Search