 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
I have a gas wall heater and the only way to turn on and off is to open bottom of heater and turn the knob on the Dayton 3E290 valve. I want to be able to run a wall thermostat but there are no places to add the wires. What can I convert the valve to so it accepts the remote thermostate Thank you
Just blowing cold air when heat turned on also noticed coils turn hot orange after u shut off therostat
I have a white rodgers 1F86 -244 thermostat and I believed it is wired incorrectly. I turned on the airconditioning and it would not start. The heat works. There are two wires from wall. One is red, other is blue.how do I hook them up to thermostat panel
I've a Carrier zone thermostat and want to remove it from the wall far enough to install some insulation padding and radiant barrier between it and the wall. I cannot figure how the plastic casing comes apart to get at the mounting base. This is the zone thermostat, which is smaller than the...
I have a magic stat thermostat that doesn't appear to have any obvious screws. It has a half cover that swings upwards to get at controls. I can jiggle the whole thing a little bit and it moves as a unit, doesn't appear to have a cover that I can remove to get at any inside screws. I need to...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
